 | Improve machine productivity |
| Confirm the accuracy of information
originating from other sources in a plant, such as
weighbridges or production machinery |
| Identify excessive machine down-time |
| Help identify material shrinkage |
| Eliminate cost of manual transcription of
data |
| Cross check invoicing to a customer or
billing from a supplier |
| Identify peak loading patterns to determine
machine and operator scheduling |
| Schedule machine maintenance based on
workload |
| Manage product inventory |
The possibilities are endless...
LOADRITE - THE TOOL FOR
INCREASING YOUR PROFITS
In a typical operation, the
loader driver will "plug-in" the Data Module to the
Loadrite Weigh indicator at the beginning of the shift. The module
remains there until the end of the shift and is then returned to
the office where the data can be "up-loaded" using the
Material Management System (MMS) software. Reports can then be run
to determine total production, etc. Once "up-loaded",
the module is ready for use again. The data is automatically saved
on the computer's hard disk.
The MMS software
enables a variety of reports to be generated so that the payload
data can easily be displayed and analyzed. for further data
analysis or manipulation, reports can be printed or exported to
Microsoft Word© or Excel©. Note: all payload data is stored in
an Access© database.
Technical
information
Data Memory Module
Memory
Capacity
250kByte (4000 to 12000 lifts depending on configuration of weigh
indicator)
Ambient
Temperature
Operating: -10ºC to +50ºC (14ºF to 122ºF)
Storage: -30ºC to +70ºC (22ºF to 176ºF)
Protection
IP54 (Data module protected equivalent to IP68)
Computer
Minimum requirements for running Loadrite MMS Software:
Pentium 166 with Windows 95 or Windows 98 or Windows NT
Available com port
CD ROM drive
50MB free hard disk space (more may be required if database
becomes large.)
(800) 266-7669
